Subaru Outback Window Tint Installation Guide

Work through Subaru Outback installation from front door panes to the remaining door glass, fixed side panes and rear opening. Plan the cargo-area workspace before peeling the rear liner, and keep the heated pane separate from plain side-glass cleanup.

Set up the Outback’s rear gate as a separate pane from the wagon’s cargo-side windows. Inspect its heater lines and wiper-area hardware, protect the cargo trim and label left and right fixed side pieces before working on the rear film.

Prepare Subaru Outback glass before applying film

The 2013 Outback manual separates the rear wiper and washer from the defogger controls and prohibits sharp tools or abrasive cleaner on the protected inside rear window. 2013 Subaru Legacy/Outback Owner’s Manual, 3-48–3-50.

Removing old tint first?

Read our 2013 Subaru Outback window tint removal guide for removal planning, manufacturer glass-care advice, and replacement-film checks. The guide clearly labels video details that are not verified for the stated model year. Prepare for a Subaru Outback sides-and-rear tint installation by identifying the exact vehicle and checking the supplied pieces before use.

Check the Outback wagon entry, including its year limit

The current catalog lists Outback wagon years 1998–2013. Keep the full model, actual year and wagon body in the order details. Provide your exact year, body and trim; pattern availability is checked before fulfillment. Request a check for an unlisted or modified configuration.

Check the listed Subaru Outback pattern

Use the Subaru Outback vehicle page to confirm the selection. Keep every liner attached while matching the pieces to the actual panes. If an edge or opening does not match, photograph it and ask for help before cutting or peeling.

Apply the matched pieces and check the edges

Protect the interior from application liquid, finish cleaning the accessible glass edges and follow the installation video and installation sequence. Pre-cut film may still need shaping on curved glass. Follow the supplied curing instructions before operating windows or cleaning fresh film.

For existing film, complete the Subaru Outback removal checks first. Confirm windshield and roof coverage separately from a sides-and-rear order. Send your vehicle details and photos if a supplied piece or glass feature is uncertain.

Your Subaru Outback fitting sequence

1. Match and clean. Lay each piece on its liner, identify its intended pane and check orientation. Remove old film and glue first. Clean accessible glass edges and seals, then protect switches and trim from liquid.
2. Fit a front rolling window. Lower it enough to reach the top edge. Wet the inside glass and exposed adhesive as the liner separates, position the film and squeegee with overlapping passes. Raise the pane carefully to finish the lower section without folding the film.
3. Complete the remaining sides. Use the matching rear-door pieces where fitted, then the separate fixed panes. Keep moving gaps, hinges and latches clear; do not trim an unexpected piece merely to make it fit.
4. Shape and apply the rear piece. Dry-check curved glass with the liner attached. Shape film on the exterior when needed, using controlled heat and keeping it moving; the final adhesive installation goes on the inside. Keep sharp tools away from heater or antenna traces and leave brake-light output unobstructed.
5. Inspect and cure. Check edges, corners and trapped solution before cleanup. Keep newly tinted windows closed for at least five days and wait at least seven days before cleaning. Cold or humid weather can extend drying; mild moisture haze can take up to three weeks to clear.

If the film bunches on curved glass, review shaping and rear-glass access. For haze, bubbles or lifted edges, use the close-up troubleshooting guide.

Choose a machine-cut MotorPeak tint kit. Estimated 7–10 days total for cutting, processing and shipping. Check your state's finished glass-and-film requirements before selecting shades.