Dodge Journey Window Tint Installation Guide
Work through Dodge Journey installation from front door panes to the remaining door glass, fixed side panes and rear opening. Plan the cargo-area workspace before peeling the rear liner, and keep the heated pane separate from plain side-glass cleanup.
Include the right rear quarter pane in the electrical-line check, not just the back window. Document the trace locations before film removal or preparation, and keep cleaning runoff off the cargo-area trim.
Prepare Dodge Journey glass before applying film
The 2014 Journey manual identifies electric rear defrosters and a radio antenna on the right rear quarter window. It warns against sharp tools that can scratch these elements. 2014 Dodge Journey Owner’s Manual, 585.
Use the Journey SUV entry through 2019
The listed Journey range is 2009–2019. A later year is not confirmed by this entry. Select the exact year, body and trim. MotorPeak machine-cuts your selected vehicle pattern; contact us for unlisted years or modified glass.
Inventory the rear-side glass
List roll-down windows and fixed panes behind the doors separately, then identify the hatch-glass piece in the confirmed kit. Note existing film or replacement panes. Plan access around the cabin and cargo area without assuming another Journey year has the same trim or equipment.
Check the listed Dodge Journey pattern
| Body style | Model years |
|---|---|
| SUV | 2009–2019 |
Use the Dodge Journey vehicle page to confirm the selection. Keep every liner attached while matching the pieces to the actual panes. If an edge or opening does not match, photograph it and ask for help before cutting or peeling.
Apply the matched pieces and check the edges
Protect the interior from application liquid, finish cleaning the accessible glass edges and follow the installation video and installation sequence. Pre-cut film may still need shaping on curved glass. Follow the supplied curing instructions before operating windows or cleaning fresh film.
For existing film, complete the Dodge Journey removal checks first. Confirm windshield and roof coverage separately from a sides-and-rear order. Send your vehicle details and photos if a supplied piece or glass feature is uncertain.
Your Dodge Journey fitting sequence
- Match and clean. Lay each piece on its liner, identify its intended pane and check orientation. Remove old film and glue first. Clean accessible glass edges and seals, then protect switches and trim from liquid.
- Fit a front rolling window. Lower it enough to reach the top edge. Wet the inside glass and exposed adhesive as the liner separates, position the film and squeegee with overlapping passes. Raise the pane carefully to finish the lower section without folding the film.
- Complete the remaining sides. Use the matching rear-door pieces where fitted, then the separate fixed panes. Keep moving gaps, hinges and latches clear; do not trim an unexpected piece merely to make it fit.
- Shape and apply the rear piece. Dry-check curved glass with the liner attached. Shape film on the exterior when needed, using controlled heat and keeping it moving; the final adhesive installation goes on the inside. Keep sharp tools away from heater or antenna traces and leave brake-light output unobstructed.
- Inspect and cure. Check edges, corners and trapped solution before cleanup. Keep newly tinted windows closed for at least five days and wait at least seven days before cleaning. Cold or humid weather can extend drying; mild moisture haze can take up to three weeks to clear.
If the film bunches on curved glass, review shaping and rear-glass access. For haze, bubbles or lifted edges, use the close-up troubleshooting guide.
Choose a machine-cut MotorPeak tint kit. Estimated 7–10 days total for cutting, processing and shipping. Check your state's finished glass-and-film requirements before selecting shades.